Definitely check out the wake 9 vid on flow 3.0, makes me think that is the better iteration of all worlds. Also. A great discussion on the Moomba owners site of 2.0 vs. 3.0, one in which Sonic was also sharing his expertise. A challenge I’ll have is space for the secondary actuator when stowed. 3.0 stows in the same plane as the running surface, rather than at X degrees up. Moomba also runs a huge center plate so not sure if in plane stowage will mess up the wave or not compared to a wedged boat; one way to find out. If GSA could also be used for something other than surfing without fear of ripping the screws out of the boat, I’d just build a set of those. I’m not sure how excited the local dealer will be with me trying to get some measurements on their plates at the boat show but I’m going to try.
For your electronics, did you use the same boards for your build as the two actuator system but with an extra relay board? I have a ton to learn about arduino to make this work, hopefully I can figure out programming before the season hits or I’ll have to settle for GSA style or Evolution style.