Chase1987

what did you make the testing device out of i'm thinking about making my main stainless base plate and mounding it to the boat with a couple bolts where the slides would be then trying to make some temp things to try different orientations.

Hey so I’m designing one for my boat. Looking at new NSS systems they actually angle toward the front of the boat creating a less than 90 angle with the side of the boat they also don’t go down just out. Why do most of the diy NSS systems go down and out. I drew up my template and then drew a line from the bottom edge down 1.5” and out from the side 2.5” this extension would put my actuator at a 26 degree angle. Does this sound right? has there been any testing to see if strait out to the side or even out and down or offset like I drew it?

What would it cost

What would it run

Could you get the plates cut for my boat if I sent templates?

The boat I’m looking at has the splash pockets right where yours are set up think there would be any way around that with a setup like yours?