Great write up and photos. Very clean job. I am embarking on very similar project for my 08 wakesetter 247. Very similar to your boat layout except a bit longer. I had a couple of questions for you.
On my boat as yours the seat bases are carpeted and I am leaving them carpeted. My bases are currently screwed down on top of the carpet. Did you screw yours directly to the newly finished painted decks and then butt the gatorstep and eBay Eva up against the carpeted seat bases?
I was looking at running gatorstep all the way through the storage lockers and was thinking I could screw the seat bases down on top of the gatorstep. Any thoughts?
the cost for gatorstep all the way through my lockers was outrageously expensive. How did the hand cut Eva work out
”After much debate I used Sherwin Williams extreme bond primer and did two coats - this was available at any local SW store and is coupon/sale eligible. I used Tile Clad HS 2 part epoxy in gloss black to seal the floor. Tile clad is only available at Commercial stores but local stores can order it in. One important note - this product needs high speed mixing and then to sweat-in. I had no idea what sweat-in was so first coat I just applied it and then little bubbles appeared all over the floor. Sweat it is to let it sit in the mixing cup for maybe 30 minutes to an hour (depending on temperature) and let the gasses from the chemical reaction come to the top”. I didn’t understand. Did you use the tile clad hs to seal the floor and then put 2 coats of the Sherwin Williams 2 part epoxy on top of that?
thanks for your help
