wet2ward

Interesting, I visualized a vertical support being better as there is no flex. Did you have yours at an angle? Can you expand on why you think the horizontal is more effective? Thanks

Here's another iteration installed on a 2007 Tige RZ2.

4 hours ago, HammerTime said:

I am considering screwing it to the flapper flange but haven't done it yet. I think a 4" schedule 40 coupling fits perfectly. I might use a rubber fernco fitting instead of screws.

Then add a brace to the swim platform.

Ok, thanks for that. Yes, I measured and a 4" sch 40 fitting is 5" od, so will fit right in! Are you planning to keep the flappers in tact? If not, do you think there is any way for water to get in there?

On 9/23/2020 at 9:39 PM, jtryon said:

everything was at Home Depot/Lowe’s 

Thanks, does it matter if I use PVC or ABS?

On 11/2/2019 at 6:10 PM, HammerTime said:

Does this look about right before I attach it together? 

Tail piece angle look ok? Length? 

Distance from taps plate good?

I have a Tige with the same exhaust flange, just wondering how you plan to attach the fitting to it? Thanks

Where did you guys buy those swoopy tee fittings?